Chris B 1 Report post Posted January 2 Hi I am looking for 2x FT16D motors for a cox chassis build not sure if there are any other makes of engines the same size out there does any one have any ideas what I could use? Chris Quote Share this post Link to post Share on other sites
big den 10 Report post Posted January 2 Hi Chris, I have some FT16D 'can-drive' motors that I am unlikely to use - 1 is a 'silver' Mabuchi that was supplied in a Nichimo vintage kit that I bought. The chassis was designed for an end-bell drive motor so the 16D is unsuitable. I also have 2 'black can' FT16D can-drives that I picked up in a 'job-lot' purchase. In the 1960s many manufacturers used different coloured cans on their Mabuchi motors but I can't recall anyone using a black can. Den Quote Share this post Link to post Share on other sites
Chris B 1 Report post Posted January 2 Hi Den. where are you located I am Sydney Regards chris Quote Share this post Link to post Share on other sites
big den 10 Report post Posted January 3 Hello again Chris. I'm a long way from you ... in Northern Tasmania! However that shouldn't be a 'deal-breaker' as postage from Tassie to Sydney is quite reasonable. You can send me a message (PM) to discuss further details. Den Quote Share this post Link to post Share on other sites
