Jump to content
xr8

Lap Counting And Timing Help

Recommended Posts

Hi XR8,

i have been using RC for about 2 years now, i had a few issues with lost communication.

 

The issues were resolved by doing the following.

  • made sure the correct driver for USB was used
  • installed ferrite cores on both the usb cable and the timing cables.

also noted that running cars that did not have caps on the motor caused the lost communication as well.

 

Since doing these changes have not had any issues.

 

Regards

Allan

Share this post


Link to post
Share on other sites

It has arrived, not bad as I ordered it last Saturday


RUBBINS RACING SO HARDEN UP

Share this post


Link to post
Share on other sites

Trackmate help needed.

 

I'm fixing a problem with Red Racers Trackmate system .. All seems pretty logical and the hardware seems pretty good but the time seller mode seems very clumsy. Am I missing some short cut?

 

To sell time to a customer you have to click on the Time Sell tab, then click on sell time, then click on the lane you want to turn on individually, then click on increase time ( of decrease ) After all that you then have to close the window and click on start ( or abort) so the customer can see the practise screen. All good but.... way too many steps for a simple command. Trouble is now there is nothing to show how much time the customer has for rental time. Is this normal?

Edited by axman

Share this post


Link to post
Share on other sites

Thanks to Joe z and boslot we are alive and I can not thank you guys enough


RUBBINS RACING SO HARDEN UP

Share this post


Link to post
Share on other sites

How good is Trackmate and the customer service!!!!!!!!!!!!!!!! We love it!!!!!!!!!!!!!!!!!


RUBBINS RACING SO HARDEN UP

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...