Jump to content
kalbfellp

Oz Rally 14/15 Rules

Recommended Posts

I have had a question asked about 1:1 cars that use small diameter wheel, and if they require larger tyres to fit the rules.

NO cars such as MIni etc that run small wheels do not have to meet the minimum requirement.

I will allow the minimum diameter to the standard tyre size, less the amount of the tread. This should allow for Truing the tyres.

Share this post


Link to post
Share on other sites

I hope you picked the slow 1

Then gazza

Going with the Bowler, should be ok, have managed to get it down to Trans Am times on the road track :D

Don't tell me that

I got the x5 to at least stay on my rally track

Then some 100grms of lead bit of oil & some superglue it goes good now just not sure about tyres do mjk do tyres for these gazza

Share this post


Link to post
Share on other sites

Could you not find something with a lower COG?...... :)

I forgot to mention

I did lower it, so it's just above 50mm just need tyres trued an glued an I'm ready to send my cars but I'll test my cars at mel's an Craig's then gazza's next week 😛😛😛

Edited by GAS41T

Share this post


Link to post
Share on other sites

Hi All,

 

What's the tyre compound of choice for this event? I use NSR Ultra grips for the Slot Rally GB series as urethane aren't allowed. I do have a pack of MJKs that were sent to me following last years Proxy WRC I could pop on.

 

Thanks

 

Ryan

Share this post


Link to post
Share on other sites

Most of the cars run MJK. We find that the NSR tyres pick up any crap from the scenery that gets knocked off. The MJK seem to just grip without picking up and dirt.

Share this post


Link to post
Share on other sites

The question has been asked about:

Ballast must be firmly attached and located within the body of the car.

 

The weight should be located on TOP of the chassis.

Sorry if the wording has been confusing.

Edited by kalbfellp

Share this post


Link to post
Share on other sites

Important information to Raid Class entrants:

 

Ninco Raid vehicles WILL be allowed to have weight placed under the chassis SIDES, provided it is no lower that the centre section of the chassis.

This is to try and equalize the performance of the Ninco's with the Avant Pajero.

 

The Avant raid is still required to have its weight on TOP of the chassis.

PM me if you need any more information or any questions.

Share this post


Link to post
Share on other sites

Front tyres cannot be any more than 1mm smaller than the rears.

Minium tyre diameter is 18mm front and 19mm Rear.

 

Please check your tyre size before posting.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...