gazza 77 Report post Posted April 17, 2010 About time Mick! Quote Quickly read this post before it is deleted or i turn grey again Gary http://www.facebook.com/Rallyproxy2017 Share this post Link to post Share on other sites
Yngwie 17 Report post Posted April 17, 2010 Well done! Persistence pays off. Regards john Quote Share this post Link to post Share on other sites
schuey19 1 Report post Posted April 17, 2010 About time Mick! Thanks Gazza, good to see you back on deck. Quote My Track- Design and Start of Build My Track- Early Construction My Track- Almost There My Track- Finishing Touches (Current Thread) Share this post Link to post Share on other sites
Count 1 Report post Posted April 17, 2010 Well done, Michael! (I wish i could understand that circuit diagram... ?) Count Quote Pretzel Logic Raceway Ask not what MDF can do to you, rather ask what you can do to MDF! Share this post Link to post Share on other sites
schuey19 1 Report post Posted April 18, 2010 Well done, Michael! (I wish i could understand that circuit diagram... :huh2: ?) Count If you come on Friday night, I'll show you! Basically the track start/finish sensors are fixed in the track on table 3. The refuel sensors are fixed into table 2. Each set of three sensors are connected to a 9 pin plug. See Track/Pit to PC Harness 9 Pin Plugs in the diagram. The seven pin round plug connects to the start light gantry. The PC Harness is the link between the PC, the refuel sensors and and the start lights. Then these are connected to the 25pin parallel connector as indicated. Quote My Track- Design and Start of Build My Track- Early Construction My Track- Almost There My Track- Finishing Touches (Current Thread) Share this post Link to post Share on other sites
