Search the Community
Showing results for tags 'Policar'.
Found 2 results
After years in the planning, musing, wishing, and mostly procrastinating, I have begun work on a couple of modular table-tops I can roll under my routed track and use to mount plastic track. The imminent arrival of the Policar track system - next Monday to be precise, and my need to have a test bed, gave it a nudge. But it is also the opportunity to create a rally and RAID track that I have wanted for well, most of my time slotting. I can run the Policar track mostly around the outside, crossover etc, then interlace it with the RAID track, using the natural elevations of the hill climb pieces So this morning, full of coffee and optimism I wandered down to our local M10 Mega (That's the Kiwi equivalent of a Bunnings Aussie-Jim), and had the nice bloke shorten some sheets of MDF and some lengths of 40 x 20mm kiln dried pine, to save me a lot of saw time. The two sheets of 6mm MDF have been shortened to 2 metres, as this is the longest I can tuck away under Oakland Raceway. The 40mm x 20mm kiln dried pine is light and fairly rigid. I had them cut 4 lengths of 5.4 metre into 8 x 1,960cm plus the leftover of 4 x 1,460 cm That provides the framing for both tables. The 40 x 20 rings the sheet, and supplies two extra stringers to run length-ways, and all I had to cut was the extra off the cross pieces sticking out below Oh look, the legs of those resin folding tables look just right. - "Off with their heads/tops" On this table I was able to pull the end rails apart, removed the two black plastic frame retainers that clip the ends of the metal frame together when storing away, and use these in the ends of the legs in the new frame to hold the legs up and away for storage. The other table I cannibalised had plastic retaining clips that wouldn't fit the legs there, so I will have to manufacture an alternate solution for table 2 legs And in they go, screwed onto the internal stringers If you do a bit of woodworking and don't own one of these, you're a masochistic mug. Two set screws allow changing of the drill bit - or setting of depth, and setting the dept/width of the screw head rebating. I am using 30mm #10 screws. I can drill a run of holes identical depth, rebated, in about 30 seconds Presto - each table took about 90 minutes start to finish once i had everything ready to go. Next up I am fitting some 10 x 20 off-cuts underneath screwed and glued with construction adhesive to the frame and underside of the MDF, for mounting of the casters this first table will roll on.