Jump to content

Leaderboard


Popular Content

Showing content with the highest reputation on 08/15/2020 in all areas

  1. 1 point
    Assembled my printer during Lockdown and have printed a few track scenery items and spectators. This is my first attempt at a car body. A little Hillman Imp. Printed in PLA with full supports. Quite pleased how it came out. Bonnet had the most noticeable 'steps' so a little sanding and Tamiya putty - we are getting closer. A very basic inline chassis file came with the Imp. It works OK so I'll print some supports and roll with it. May need to tweak the wheelbase but getting there...
  2. 1 point
    Mate, awesome. Tamiya putty applied with finger works for me, you can push into the grooves and finger smooth, sand underwater with 400grit, repeat. Final it off with 1200 grit, then a thin coat of resin on the inside for strength, some like to use bog roll and supaglue. This one looks like it needs a chop top to give it some street cred.
×
×
  • Create New...